Well, I did connect the non-tach motor to my dc power supply and at 2 volts it spun nicely and even turned the wheels at about 1.2 volts. So I guess I'll go after the Tach motor next. However on previous checks, the tach motor starts moving when I advance the thumb wheel to 1 smph. So I would think that the non tach motor should be turning as well. Not waiting until 7 smph and struggling to move. I'm wondering if there might be a problem with the wires from the board to the motor.
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
|