Each loop of my layout is split into 4 Power Districts. Each Power District is power by it's own PW ZW. Each ZW has a volt meter and ammeter for me to monitor voltages and amps. I experienced problems once when a powered car straddled 2 Power Districts. A lighted passenger car straddled 2 Power Districts for a few minutes and the wiring in the car literally burned up. I have an emergency disconnect that kills all power immediately. As a result I make sure no cars and no engines especially straddle Power Districts. I installed poles with blue LEDS on top to show where the insulated pins are installed for each loop. That way I can visually see where engines/cars are paused in relation to Power District insulation points are located.
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
|