Dale, did you try moving the resistor to see if it works?
I like the idea of the 100 ohm, it probably would have been a good idea for all of them. I believe mine were zero ohm, but I may missed the value. In any case, since I just wanted to ground the pin, the wire did the trick.
That part number comes back to the same capacity EEPROM, so I suspect it's just an updated (or old) part. The first set of pictures was from a 1.0 version CAB unit, that's the only one I actually looked at the part number on.
The beauty of all of this is the blue modules were junk anyway, I'd never use them again for anything once we've moved well past 1.3. 
