@DoubleDAZ thanks for mentioning this. Yes, the passing siding as shown is about 0.2 inches longer than the parallel main. This may require some cut track, if not doing so would make the joints in the mainline too loose.
I did change my default tolerances a couple of years ago. When I did the most recent screenshot, they were set to: dx = 0.15; Angle 2.5 deg.
It's interesting that SCARM considers a 0.1 inch overlap to be less than a 0.15 tolerance. When I change it to 0.1 or less this connection is not joined. Think I'm going to leave it at 0.1.
