bent the c/s lever and checked continuity of wires in & out All good. I did find something that doesn't look right in the tender. The switch has 1 wire going to a male plug on the mother board but the other wire is going underneath the mother board and soldered to 1 of the pins Is this normal. or should I unsolder wire. solder wire to a female pin and insert into plug next to the other wire from the switch ? One other question, since I don't have any steam sound no exhaust or chuff. just bell & whistle would you think its in conventional mode If it is in conv. mode. places to look would be the switch or one of the boards ( I was told the following boards were replaced, radio , ir receiver, power supply. I did go in to lio. parts & checked the #s What boards pertain to sound he didn't mention the RS board with chips .
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
|