Skip to main content

Reply to "MTH # 50-1028 DCS commander"

We're talking about two completely different devices on this thread.

 

The #50-1028 DCS Commander is intended for HO, is stationary, is limited to 6 amps and 10 engines, has a subset of DCS commands, and runs only DC voltage.

 

The #50-1033 DCS Remote Commander set is a handheld remote plus receiver that can only run PS2/PS3 engines that have a factory-assigned DCS ID#. It can accept a power supply like an MTH brick-type transformer or may be run in "passive mode" where it gets its power back-fed from the tracks.

 

The instructions for either device may be obtained from the MTH web page for each device. Further, both devices are discussed in greater detail than their instructions in The DCS O Gauge Companion 2nd Edition.

 

This and a whole lot more is all in "The DCS O Gauge Companion 2nd Edition", now available for purchase as an eBook or a printed book from MTH's web store site! Click on the link below to go to MTH's web page for the book!

 
 
×
×
×
×
×