Skip to main content

Reply to "Benchwork - Wiring - adding elevations"

Hello All,

For just a brief illustration, I have an MTH AIU SW1 "IN" is tied to ground and "1" is tied to SW1 input of the controller board. Controller (32A3) gets an interrupt when these inputs go from a pullup high to ground. The interrupt sends data over the air to the remote board (WE01) which then energizes or de-energizes the relay it is assigned to toggle. These remote relays will be used to control block power and turnouts. The relays are rated to carry the load of any of the isolated power blocks. The remote board has a 5 VDC power supply which uses the 18 Vac of the always on power block feeds. Now I just need to mount the remotes and wire to the AIU's  Sorry this took so long to show, I did not have an idea on how to set the MTH system up to power and control the AIU's. I didn't know how to get the battery case off the handheld remote. lol That is solved, and now to get busy building again!IMG_32A3IMG_WE01

Attachments

Images (2)
  • IMG_32A3
  • IMG_WE01
Videos (1)
32A3
Last edited by Aegis21
×
×
×
×
×