not sure what happened to my last post, ??? Anyway, I have wired four blocks and one ross switch so far. All tested out good with an MTH steam engine. Train was sensed in the block and out of the block, signal was between 9-10 90% of the time. Had a few scattered lower numbers, but a wipe down with mineral spirits cleaned those up. Ross switch is wired for AIU control and auto non derail function. Both methods of control are verified. Things are looking good and this covers about 20% of the layout. Have to stop for a moment while the 3d printer completes a block power mount which I will need due to the added blocks the trolley line has added. Still cannot figure how to keep the ross switch indicators lighted red or green. Maybe it is not possible...
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
![]() ![]() ![]()
|