Skip to main content

Reply to "PBW needed"

The resistor hole spacing on the the Rev. 3A version of the WD board is 6.5mm.  I picked resistors that would fit, typically 1/8w.  Some of the precision 1% resistors of higher power ratings are short enough to work also, just check the datasheet before you order them.

Would there be an issue with mounting a physically "oversized" resistor to the PCB vertically (where the bottom lead goes straight down through the hole and the top lead has a ~180 degree bend to line up with the other hole?  Would this arrangement add unwanted capacitance?

Last edited by SteveH
×
×
×
×
×