Two questions for this discussion. I have two circuits in my train room. One is in the center and one is for the outlets along the wall. Which of the two would b best to tap into or doesn’t it matter?
Second I have a ground bus shielded I run around the layout and then tap in unshielded to run under the upper level in problem areas for a 3 track main. Is this fine or should I run the ground separate? I had been told not to run anything along side the common wires for DCS purposes. Lmk
fi ally I do have DCS issues when I turn up Dales amplifier high enough to eliminate all the trouble spots. dCS does not stop but it losses horn and speed functions till it’s out of the area with the antenna wire. Any insights appreciated
