Skip to main content

Reply to "Watchdog Signal"

@upguy posted:

After powering up a siding with an engine on it which puts the engine in conventional, I just hit the startup button (3) on the DCS remote after selecting it, and the engine immediately goes into command mode.

This works well but one word of caution: I've had brand new DCS engines come up in conventional and take off at full speed.  If this is how you choose to run your layout, I would make sure all of my DCS engines come up in conventional Neutral.  If not, there is a procedure to lock the engine in conventional neutral. 

https://ogrforum.com/topic/753...86#75340558691199886

Trust me, there are only a few worse feelings than watching a prized engine race to a crash.

Tony V

×
×
×
×
×