The yellow light on my Legacy Base dimly flashes all of the time. Anybody know what this means? Everything seems to be working OK. I'm running V1.52 software.
Ken
Original Post
Replies sorted oldest to newest
From page 76 of the Legacy 990 Controller Manual (link below):
Note: The status light (yellow on Base, red on remote) will stop fl ashing quickly if the update is successful. If the light will not go off and blinks a number sequence slowly, it is indicating an error code. If you encounter this please refer to the following table to diagnose the cause.
Yeah, I saw that in the manual, but I'm not updating anything and haven't for some time. The light does not blink a number sequence, it just flashes constantly.
Ken
kanawha posted:Yeah, I saw that in the manual, but I'm not updating anything and haven't for some time. The light does not blink a number sequence, it just flashes constantly.
Ken
Do you have any LCS items attached? On mine, the yellow light will continuously flash when the PDI/9pin cable is connected to the base and powered up.
I have an SER 2 hooked up to mine as part of the connection to the MTH Wi-Fi system and the yellow light flashes constantly, but everything seems to work fine.
The manual also says, "Yellow Light (status) - Used for feedback during special functions of Base".
That was it. I unplugged the cable going to the serial port on the base and the light quit flashing. So it looks like that's normal. Thanks!
Ken
