Hi, My layout is all conventional, I have never had or even seen a Legacy or TMCC layout and have been thinking about getting a Legacy 990 Command Set to use on my layout. I would like to try out some of the newer Legacy motive power engine sets.
I have three loops that run off a CW-80 and a ZW. All of the loops have the U post / outside rails connected to each other. The two on the ZW is so I can go from the inside loop to the outside loop through a set of switches. Both of these loops run off the ZW. The CW is got a jumper to connect the outside rails so a set of 252 crossing gates will run off the CW accessory power when a train on either the inside train running on the CW goes through a block or the outside loop train running off the ZW goes through a block.
The question is will this be a problem with the Legacy system operation??
Thanks,
