Converting MTH Premier to 2 rail.
I searched but did not see how to:
1)Remove the trucks from an MTH Premier Bulkhead flat
or
2) Remove the pulpwood load
I removed 4 screws on each end and can't for the life of me pull the any of the structure off from below.
Thanks in advance
-Mark
Replies sorted oldest to newest
You also need to remove the two screws under the centre spline. My car is item number is 20-98234
DCRFAN,
Thanks for the reply. Looks like they modified the molds ...those 2 center screws are not present on my car 
Thanks again
-Mark
Rather personal request, 
Got it!! Had to remove the 2 screws holding each of the bulkheads, then a little prying and it came right off. I'm going to body mount the couplers. Should I just use MTH 2 rail trucks or is there another set of trucks that would work?
-Mark
I put Weaver 2 rail trucks with a spacer washer under mine. IIRC the MTH 2 rail trucks will put the car at the right height for Kadee couplers and look ok. I used MTH trucks under their high cube box car with good results.
Greg
Greg,
Thx for the information, much appreciated.
-Mark
Access to this requires an OGR Forum Supporting Membership
