No TIU/WTIU Found

Are you running a WTIU or a WIU/TIU?

If the later, what is the firmware version of the WIU and of the TIU?

What is the version of iOS app software and Android app software?

I see you've been on here since 2009, how long have you had the DCS system?

I don't know if you are asking for help, or making a statement.

Rod,

I am asking for help and complaining all at the same time, that's how frustrated I am.

I have an old, probably one of the first TIU's made, I have a separate WIU.  All the firmware is up to date, that I know of through the app, I don't know how to update the WIU by itself.  The iOS software on the tablet I use and the phone are up to date. 

I never, and I mean never, had an issue for all the years I used the handheld remote, but as soon as I switched over to the app, its been one issue after another.  The main issue is that the app doesn't seem to stay connected and I have no control over the trains, it just freezes.  I've checked everything I can think of, I'm just frustrated that what is made to simplify the hobby and make it more enjoyable has done the exact opposite. 

Darren

@DarrenCaruso I had a similar issue when using the app and the WIU, I kept losing connection to the TIU. Everything worked fine with just the TIU and handheld remote. I narrowed it down to one of my PS2 engines. It worked perfect with just the TIU and handheld, but when I tried to use that engine with the app and WIU I would get the error message about "No TIU/WTIU Found".

I did a factory reset on that offending engine using the TIU and handheld. I then re-added that engine to both the handheld and the app. This solved my connection failures with the app and the WIU.

Hopefully you don't have a lot of DCS engines to check. I was just as frustrated as you, but doing the factory reset on that engine solved my connection problems with the app and WIU. Good luck.

Troy

Troy,

Thank you, I will give that a try and let you know if that works.  Most of my locomotives are PS2, but the two diesels are PS3. 

Darren

I reset the app, reset the engines, switched the WIU to my home network.  This got rid of the "NO TIU/WIU Found" error message but the app is still unresponsive.  I'm not sure what the problem is.  Upon start-up, I can start the engine, but then the app is non-functional, almost like it freezes.  I can try refreshing the engine list and the app, but it is sporadic, and function of the app lasts for a brief moment, then back to frozen.

Mine does not work great with my home router. But my home router is 7 years old and full of spider webs. I switched back to MTH and everything was fine. --Until I got an email.-- The notification popped on my iPhone and everything immediately went haywire. My theory is that even though I switched to "MTH" (Local Area Network), internally I still had a connection to the spider router. So I pulled up LUCI and got rid of the connection to my home WIFI that got set when I tried "Home" earlier. Now all is good.

Using the link below, on page 6 go to the section 'For Routers that Require Manual Setup (no WPS feature)'. Reverse steps 12 and 13. In other words set the ESSID from your home wifi name back to "NONE". I'm not sure the encryption matters at this point.

https://mthtrains.com/sites/de...ction/50as19846i.pdf

Steve,

Thank you, I will gave that a try.  I'm just frustrated that any of these steps have to be taken in order to get the app to work.

Darren