Skip to main content

Howdy Friends!

Here's one that has me puzzled. I have an MTH-Ives 3245R Loco Product # 10-1218-1 (3 volt board) that runs normally in DCS for about 30 minutes then cannot be controlled by hand held remote. It maintains set speed and all and when but when I hit the "read button" it says "Engine not on track" ... Shutting off the power and waiting a minute and powering up again I can regain control. Does my loco have early onset Alzheimer's or what? I have track signal of 10's, TIU and Remote are both 6.0 ... It has to be loco ... But what?  All input is welcome.

Original Post

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×