My Z1000 shorted out and was dead. So I replaced 3 things on the board based on feedback I got from this forum. I think you can tell which 3 things I replaced from the picture. Now this thing behaves very oddly. When the throttle is at 0, there is no voltage on the outputs. As I turn up the throttle the voltage increases. That part sounds great. When I put a legacy engine on the track with the throttle at 0 and plug the transformer in, the engine fires up, with 0 on my volt meter! Also, when I turn up the throttle the bell starts ringing!
My question is, can this be fixed or is it trash? I would like to get this working if possible.
