Skip to main content

Gentlemen, Has anyone out there successfully removed the center rail on Atlas O Gauge 3-rail track and switches?  Reason:  I have switched to Dead Rail battery-powered engines, and want to run both 2-rail and 3-rail engines and cars on the same track.  (I also understand the need to shim the switch guardrails and/or the frog bottoms to keep the 2-rail cars from clunking their way thru these hi-rail turnouts.)  BTW, battery-powered engines tend to run smooth as silk, especially when paired with DCC modules for finer motor control.  And they are fairly easy to convert. 

Another reason for wanting to modify this Atlas track is that I have gobs of it, and I couldn't afford to buy 2-rail hi-rail track...even if it was available.  Said another way, being retired, I have more time than money.   And I'm fairly certain that, when properly ballasted, this stuff should look at least a tad more prototypical than its center-railed older cousin...maybe even 2-3 tads!   So, any thoughts on this conversion would be greatly appreciated.  Stay safe.  JP

Original Post

Replies sorted oldest to newest

I have accidentally removed the center rail while working on Atlas track.  It is easy to do.  Removing the center rail leaves a mold mark down the center of the ties.  You might be able to cover it with ballast but this may be hard depending on the look that you want.  

The switches are wired for 3-rail which means that both outside rails are connected.  They will short in 2-rail operation unless you isolate the outside rails.  This won't matter if you only use battery power.  2-rail conventional or DCC will be a problem.  

I have had problems running 2-rail equipment through O-72 switches because they are too sharp for anything but short cars and engines.  You do need to modify the guard rails as mentioned above.  I wouldn't attempt any 2-rail equipment with any curve smaller than O-72.  Scale passenger cars with 2-rail wheels are an issue but can be modified to work on sharp curves.  I think the smallest Atlas switch size you should use for 2-rail equipment is a #5.

I think that you would be better off selling your gobs of 3-rail Atlas and using the money to buy 2-rail Atlas if your goal is to run 2-rail battery or DCC.  NH Joe

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×