Skip to main content

Hello everybody,

While most of my trains are Lionel by far I will be getting into MTH DCs a little. I purchased the mth companion and noticed you can hook it up via the remote to the Lionel 350 transfer table using a TIA controller. I am using SC1 and SC2 Lionel accessory controllers on my layout. Can I hook up the 350 transfer table using the Lionel switch controllers? If so please advise where I may be able to get a wiring diagram if it is available. The MTH companion book is great. Why does not lionel have something like this??? Also, is there any information available that would show how to hook up my other line accessories to the SC1 and 2.

By the way, if anybody has an extra 350 Lionel post war switch controller I can really use one.

Much thanks for all your help, very much appreciated, Jerry

Original Post

Replies sorted oldest to newest

Jerry,

Below find links to the PostWar wiring diagram, then a link to the modern reissue manual.

While the new version uses modern electronics, the controller is practically the same.

The original service doc below shows the wire routing.. The new manual show how to hook it to your SC1 or SC2 to be controlled under tmcc.

Hope this helps a bit.

Original Service Document

Modern Version Manual

 

Finally here's a link to the SC2 manual that show various accessory hookups.

SC2 Manual

 

Link to Lionel page with video tutorials.

Tutorials

Last edited by EscapeRocks

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×