Hi...Can someone help me convert this to a Fastrack layout (Not Realtrack) with some type of train software- I wanted to know how many different track sizes/pieces needed & where wire buses to every piece goes- the length & width of table is not a problem I can go bigger if needed-I am using Fastrack because it`s what came with my 3 sets- It would be greatly appreciated!- I am new to the hobby & could use a little help!- Thanks!-Sal
Replies sorted oldest to newest
Image is too small, & Cropped.
@Sal V I found this reply from you in another topic with a larger image of what appears to be the same layout as the smaller image above.
Your question here is where to put the bus wires. Answers would depend on your choices for the following questions:
Detailed answers would be helpful.
@ADCX Rob posted:Image is too small, & Cropped.
@SteveH posted:@Sal V I found this reply from you in another topic with a larger image of what appears to be the same layout as the smaller image above.
Your question here is where to put the bus wires. Answers would depend on your choices for the following questions:
- Which side of the layout will your transformer(s) will be located?
- Will you be operating: Conventionally, Lionel TMCC/Legacy, Lion Chief, and/or MTH DCS?
- If conventional operation is desired, do you want to control more than one locomotive at a time?
- Do you want to divide the layout into electrical power districts or blocks?
Detailed answers would be helpful.
I wanted to run 3 trains Conventional with MTH z-1000/ a Lionel CW80/ & Lionel Power pack a Polar Express RTR set bump & And a bump n go Trolley on a small MTH 30watt transformer
Access to this requires an OGR Forum Supporting Membership
