I cannot get my line master big boy programmed with my legacy 990 remote control I followed the directions multiple times reset the controls started over multiple times and the most I can do is turn on the rear light was turning up the power I programmed it into my remote control I hit the power button there’s no chatter there’s no bells and whistle’s just a light on the coal car
Replies sorted oldest to newest
Switch the engine to PROG, turn on track power to 18vac, enter the address you wish to use (XX), press set on the CAB2, the horn blows, turn off power, switch the engine to RUN, turn the power on again to 18 vac, press eng on the CAB2 and enter the XX number you used, press the ON button on the CAB2 (the lowest left button on the key pad). Operate the engine with the CAB2.
Is that what you did?
What's the exact Lionel product number?
Access to this requires an OGR Forum Supporting Membership
