I was planning to put a tsunami soundtraxx and an Airwire G3 or G4 into my Weaver CNJ red baron RS3. This is a black box engine, with horizontal motor and single drive shaft.
I bought the engine about 22 years ago, and it hasn't been out of the box except for a couple of test runs.
I tried to fit a G3 into the body in place of the old reverse unit, but the board is too wide to fit inside the shell, and it must sit flat, owing to where the motor, weights, and drive shaft are placed.
Is there anybody else who has had this issue? If so, what are my options?
Thanks
