Skip to main content

I am building a layout based on Ken's Lionel Train table design.  I have the table and track layout done and am working on the wiring.  I have a Z1000 brick and controller for power.  My question is do I really need the controller or can I power the track and accessories directly from the 18 & 14 volt outputs from the brick?  My next question is would it be beneficial to setup power blocks and insulated rails for some automation, and if so any suggestions would be greatly appreciated?  I plan to setup the control panel with an iPad for train control since this will be operated by my grandson who is quite proficient with the Amazon tablet version of the iPad and I want him to be able to use the voice control as well.  The rest of the control panel will be the switches and operating accessories.  Does anyone have any suggestions for adding a parental speed control when using the Remote and/or the iPad App?  I personally think the would be a helpful feature to keep the trains on the rails and not flying off into the sheetrock or windows.

Attachments

Original Post

Replies sorted oldest to newest

There are a couple of benefits in using the Z-controller to set the track voltage at something less than 18 volts AC, like around 14-16V.

  • This is another way to limit the top speed of the locomotives.
  • If using FasTrack remote or command switches, running them at a lower voltage is better for their longevity.



Regarding insulated/isolated sections and power blocks to control accessories, this would perhaps require modification of the track plan and require either replacing some of the track and/or modifying pieces to eliminate the metal strap under each piece of track (10" straights, full curves, and switches) in the isolated section that ties the two outside rails together (thereby insulating the outside rails in this isolated track section).  This can be done, so if it's something you still want to pursue, more specific recommendations can be made for how to accomplish this.

If so, please let us knowing what accessory(ies) you want to activate with isolated track sections(s).  Some popular choices include a crossing gate/signal, and gateman.

Last edited by SteveH

Add Reply

Post
The Track Planning and Layout Design Forum is sponsored by

AN OGR FORUM CHARTER SPONSOR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×