heres the list I sent
1) The grease you recommend/sell for motor gears.
2) Red marker lights (part E in a diesel PS2 upgrade kit) actually red tender lights for 20-3291-1
4) The wireless drawbar for 20-3291-1 it is 45mm, if a 50 exists, I would take 1 as well. This would allow me to run on O54 with the apron up.
5) The harness for 20-3291-1 that allows it to control the lights and coupler on aux water tender 20-3271-3. All the literature indicate the loco should have the harness. Mine does not. Page 3 of the 20-3271-3 ser manual shows a picture of the tether. Page 5 of the 20-3291-1 user manual talks about the tether, but the picture seems to match my loco. No tether is shown (the wire on the left is for coupler control),. No tether in my tender.
6) 1x FA-2150005
7) I am doing a PS2 Diesel upgrade on 20-2210-1 The instrctions call for me to use the ditch lights for the number boards. There are 4 number boards, but only 2 ditch lights. I checked on the O-Gauge forum and it was suggested that if the ditch light circuit could support the interior lights (part K from the upgrade kit that I could use 2 of those and therefore have 4 lights.
8) Hope against hope do you have a shell for 20-3070 (undecorated aux water tender?) I have 20-3271-3 and was going to try to remove the lettering, but if you have this, woo hoo!!!
