Skip to main content

I understand that you can link the Cab1 with the Cab2 with the "Y" cable that comes in the 990 set to use them both but is there any way to link them if you use a TPC 400 to control Conventional engines?

 

I don't see it but maybe someone who knows better does. I have a TMCC Lock-on in use for its circuit breaker protection from my Post War ZW.

 

Thanks in advance.

 

Mike

Original Post

Replies sorted oldest to newest

Thanks guys,

 

Chris, the manual falls a little short. It shows the connections between the TMCC and Legacy base but then shows the third leg connected to a computer. I went through the Tutorial Videos on the Lionel site and there is one that shows how to connect a TPC to the TMCC and the Legacy bases using the Command Base Cable plugged into the third leg of the "Y" connector.

 

This problem solved.

 

Mike

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×