Okay...the app is installed...everything seems to recognize the other...so-to-speak...but, I don't have any engines in the engine lists...active or inactive.
My DCS remote works as usual...note I didn't type "normal."
What is going on with the App??
Replies sorted oldest to newest
I don't have any engines in the engine lists...active or inactive.
Did you add any?
Really...? That could be a problem. Guess I thought somehow "read" them...but...
I have done the same repeatedly. You may get a screen during the refresh that shows the addresses in the background. That doesn't mean they get added.
You have to use the "add new engine" function each time for each engine. A short cut is "add another" after adding each.
Larry,
Check your E-mail.
Works the same as using a new remote. There are no engines in it until they are added.
Yep...this is about as dumb as I could be. Too impatient to read the book...
LOL!!
Don't beat your self up too much. There isn't anyone on here, including myself, that can say they haven't done something dumb.
This takes the cake...
I had a bad day some time ago when trying to use the new pro app after upgrading. I kept thinking why won't this app see my engines and run them? To make things worse, I got that screen I described above sometimes where it would show addresses. Sometimes it would say TIU not found?
I couldn't figure out what happened so I walked away. After some time passed I went back. When I opened the app it finally hit me. The engines I was trying to run, were never loaded into the app. They weren't new and were in my remotes. They also may have been in a different device using the app, I don't remember now. It was another cause of what I describe as poor housekeeping.
Access to this requires an OGR Forum Supporting Membership
