Not sure if this is for the Layouts section or the Electrical section or both.
I am looking at interconnecting two Fastrack starter sets. Each will run off its own wallwart power pack. Do I need to isolate them from each other?
In the partial layout diagram below, the Yellow and the White are the two starter sets. The red track section is the Fastrack 1-3/8 that has the jumper for the center rail.
- If I need to isolate them, will removing the jumper suffice?
- If the jumper is removed, will the trains stop there or pass through on momentum?
- Does that create a problem for the steam engines where the tender is still on one loop and the engine on another?
Thanks for any advice,
Walt
