Skip to main content

I have a pair of K-Line Switchers, they both have been great and really pleased with them.  Recently one of them has lost its horn and bell?  The other sounds are all present, but just those two features are missing!  Any ideas??  Obviously, with my advanced logic (?) I have determined it is not....... the speaker, remote controller, operator error, track power or signal strength, doubt that it is a board problem.  Maybe a firmware, chip problem? Heck I don't know.

Original Post

Replies sorted oldest to newest

GGG, Did exactly as you said, and they responded fully, all capabilities are restored!  As the engine is K-Line the user manual had nothing about doing a reset.  When I got to the step of enter the code, I didn't know what I was going to do.  So decided to shut it all down.  When I picked up the remote, I accidentally hit the 2 key, and the engine just started up, blew the whistle and came totally alive!  What luck.  Again I THANK YOU a lot.

Don

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×