I had to pull the shell off my new Lionel Mikado to fix a smoke leak when I blew the whistle. Problem is the headlight wiring harness was so short, before I knew it I had pulled the wires out of the contacts. Need to know what size this is???? Looks like 24 AWG wire was used to the headlight but this is the smallest of these connectors I've seen. Also if it can be identified, where can I get some?
It's the front two pin I need.
Replies sorted oldest to newest
Gary, The connector is made by JST. Measure the spacing. Its either 2.5mm (.1") or 2mm. I have them both in stock. Digikey has them as well.
You will need a crimp tool for the pins though.
2mm
https://www.digikey.com/produc...5/455-1163-ND/608605
2.5mm
https://www.digikey.com/produc...5/455-1003-ND/527227
Pins will be shown below.
Pete
Actually, it may be a 1.5mm connector, also a JST one from the ZH family. I can't tell from the pictures, but just measuring the pin spacing will confirm what you have.
Great I’ll go measure right now. Thanks guys
Access to this requires an OGR Forum Supporting Membership
