Skip to main content

I have the new style K-Line Retro Manufacturing operating accessory (K-42403) with an operating forklift and an animated "sidewalk sweeper" figure which connects (somehow) to an actuating arm located underneath this accessory. I have the figure (Part #K-4011-04-01) , but no clip (or pin or link or something) for it, so I can't connect it to an elongated slot in the arm that provides motion along the sidewalk. 

I could probably custom-make a clip - if I knew what it's supposed to look like. If you have this accessory, I hope you would take the time to draw the clip (or whatever it is) and send me the drawing by USPS. Or e-mail it to me so I could "copy cat" it and get this spiffy accessory working again.

With appreciation,

Mike Mottler   LCCA 12394
22 Water Oak Drive
Conway, AR  72034
501-327-8747
mottlerm@gmail.com

 

 

 

Original Post

Replies sorted oldest to newest

TOTRAINYARD:

Thanks for a prompt response. The photos you provided didn't show the underside of the sweeper figure. My sweeper figure has two small indents on its underside, so I suppose that's where the pins should go -- attached with glue.  Since I'm not a skilled craftsman, I don't have a small parts drawer with a pin that could accept a "c" washer. I'll keep on thinking ...

Mike 

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×