I hope this is the right place for this post, anyway I have 2 manual 0-36 switches on my layout and was wondering if there was any way to wire them to be ran off the command systems. Attached is pictures of the underside of one of the switches any help would be great.
Replies sorted oldest to newest
I'm confused are they manual or remote switches Manual have no motor so unless your looking to put the motor in them the answer is no. Now putting a motor in them not sure how easy/feasible that would be.
They are both manual switches. I only noticed the terminals on the underside that's why I asked.
You can run them off of a SC-2 or ASC after converting them to motorized versions. There are surely several ways to do this, but this one is ingenious and quite straight forward(adapt for the FasTrack mechanism):
Thank you for the video.
The markings are on the bottom of the manual switches because they use the same molds and metal plates as the remote ones. The motors and PCBA are omitted.
Access to this requires an OGR Forum Supporting Membership
