Hi everyone! I just got my chance to hookup my new WTIU earlier this week and I am not able to load MTH engines thru the MTH APP. I've updated my MTH APP (even deleted my orginal APP, than re-installed from the app store). I tried several ways (thru my home network [both wifi & hard wired, & MTH Network]). I even brought the WTIU out from under the layout and setup a card table within 4' of my route w/wifi and laid down a test track w/engine on it! I can see the WTIU in both my network and the MTH network. Again I tried all the different methods with the same results. Do I possibly have a defective WTIU, or am I doing something wrong??? I've even looked on YouTube after searching on the forum. I even hooked up my half dead TIU to make sure my hookup on the card table with engine & track was OK, it was. I've used DCS every since 2005, so I'm not new to it.
Original Post
