I had a derailment and the breaker tripped. I have been able to reset it in the past. The 7amp switch is stuck now and I can’t reset it. The brick light comes on but there isn’t any power to the outlet plug? Thanks in advance.
Original Post
Replies sorted oldest to newest
What are you using to interface the brick to the track?
This is just on a 12 test track now. It is running through a TMCC controller.
Did you disconnect the brick from the "layout" completely? I ask because while the initial short has been removed from the track, there could be damage or an issue in the wiring, so removing those variables will help isolate where the problem resides.
I did remove it from the track. I then switched to another brick I have and the locomotive functioned properly.
The 135 brick does not put out any voltage?
The breaker may have gone bad, it happens.
That is what I was thinking too. It wont move at all. Can it be replaced and if so, where would i purchase one?
Thanks
I don't have any 135W bricks to look at, but I'm sure that part has been posted here more than once.
John Thank you. If anyone has one, please contact me.
If you can't find an exact replacement for the PH 135's internal breaker, it could be bypassed and you could connect a 7.5A Snapac breaker externally.
7.5 Amp PP11-0-7.50A-OC-V https://www.onlinecomponents.c...50aocv-10090644.html
Steve Thank you. If I cant find the correct breaker, this makes perfect sense.
If you need a 135 brick, I have one that I’m planning to sell. PM me if interested.
