Skip to main content

There seems to be multiple wiring instructions but none of them seem to work.

I connected the black wire to ACC GND, red wire to NC (green lamp) and yellow wire to NO (red lamp). It does not work. The green lamp is on until the 153IR is triggered but the red lamp does not light. I tested the dwarf signal and both green & red lamps work so it is not the lamps. Does anyone know how to make it work with a 153IR controller?

Original Post

Replies sorted oldest to newest

There seems to be multiple wiring instructions but none of them seem to work.

I connected the black wire to ACC GND, red wire to NC (green lamp) and yellow wire to NO (red lamp). It does not work. The green lamp is on until the 153IR is triggered but the red lamp does not light. I tested the dwarf signal and both green & red lamps work so it is not the lamps. Does anyone know how to make it work with a 153IR controller?

Rob, I use the regular size block signal but the wiring should be the same. The 153IR is set for aux power. The extreme left 2 piece black wire is connected to common ground. On the 4 pin connector the green wire is auxiliary power set at 10 volt. The yellow, red and black wires are as you see on the signal. Hope this helps. Works perfectly.

Attachments

Images (2)
  • 3B6EEDBC-0146-44E1-95AF-0C8EB63FB7BB
  • 1C6F7042-3AAA-41B5-A2E7-BB88D3223F90

Add Reply

Post
This forum is sponsored by Lionel, LLC
×
×
×
×
Link copied to your clipboard.
×
×