Skip to main content

Replies sorted oldest to newest

Charlie, thank you! When the gate is closed and the trains are running I can still duck under but I stop the trains and open the gate when I need to go back and forth often.

I wanted a swinging gate, instead of a lift or drop, because I think it's more natural and less prone to damage.

This forum has helped me tremendously along the way!

John and Greg

 

Those are nice......would love to do that next to a closet door that I have in the basement.  Questions(s) for you.........my layout currently is powered from the transformer to the terminal track and that's all.  In order to expand I will need to run some wire under the track which I can hopefully figure out but how do you keep your connections smooth and operational with the gate or lift out sections?

 

Thanks!

Sorry, I just found this question from you. Here is a photo of the unit wired. Note the wires running the length. Simple wire nuts, remember, my layout is temporary (Just took it down this week and stored it all.)

 

All the lifting, I never had a connection fail this Christmas. The two wires in the middle are for a tower on the top side. Oh yeah....move the chain from the middle at the bottom, to the outside. This is shown in the last picture.

 

Hope this helps you, Greg

 

(Oh yeah, think about making the track on each approach side of the bridge "dead" when the bridge is up. Here is a link to why you should!   )

https://ogrforum.com/d...04#12129987958270504

 

hinge up wired [1)

 

lift chain fixed

Attachments

Images (2)
  • hinge up wired (1)
  • lift chain fixed

Santa Fe VA, I ran a 10 gauge common ground underneath the track below the Benchwork. I also have four conductor trailer cable, two conductors are for the two mainlines and the other two are 12 volts for accessories and 14 volts for switches. The bridge is powered with flexible wires on the hinge end. I use Jim Barrett's protection system on both sides to remove power from 4' feet on each side when the gate is open. I have a separate protection relay and micro switch for each side so I don't have to run wires across the gap.

Ingenious fabrication work John and Greg.

 

Here are a few photos of my now 10 year old, "old-fashioned" Jim Barrett designed piano-hinged Drop Section when I had it removed, recycling it for the second time from a dismantled layout over to my little 9x16 round-the-room attic layout. In first photo it is removed and lying upside down. It shows the lever, and brake cable that triggers the transom catches. The second shows the "loop" where the wire run connects to the fixed layout. It has continued to work out well[with some "first aid"] in my very compressed space area. I need to reinstall power interuption lever switches or perhaps check on a more modern protection system..  

100_1321

100_1322-002

IMG_1636

IMG_1544-001

Attachments

Images (4)
  • 100_1321
  • 100_1322-002
  • IMG_1636
  • IMG_1544-001
Last edited by Dewey Trogdon
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×