Skip to main content

Gents---- I set up this Wabash 3424 car on my inside siding, and when I switched the train into the siding the locomotive immediately went dead.  I believe I installed the low bridge tell tales correctly, but i would like a little advice.

I used the taller set of blades.  The base is locked in tight to the O gauge track.  I am wondering if the blades are touching the center rail somehow, but I look forward to some advice.

Original Post

Never got an answer? I spotted this searching for tell-tale height info .

That base grabs the two outer rail flanges, of the two outside rails.

If you have it on correctly but it shorts, you may have a "dip" in your center rail.

 A few wraps of electrical tape around the post holder under the position of the center rail might help.

Hope you figured it out!

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×