Hi
Was wondering how many of these signals would I be able to run on the access port of a mth z4000? I know I would be better off using a separate power supply but just wanted to know for my information. Also what is the rated amp and volts for each of them? Thanks for the help.
Tony
Replies sorted oldest to newest
I can't imagine those draw much power, I suspect you can run a ton of them. I don't have the spec's for the signal, but those LED's are pretty light on power use. 
Gunrunner,
I assume it doesnt matter if I ran them under the 10V access port? I am currently using the 14V access port for a Coal Tower.
Thanks
I doubt they'll care at all.
Atlas 6931 dwarf light They can be connected directly to Atlas switch motors, but still require power, 6 to 22 VAC or DC, to the PC board supplied. Click on the underlined phrase to access information and a wiring diagram. Bases pictured are not part of the dwarf light.
They can also be used with the Atlas 6924 universal relay board. Click to access.
Since these are LEDs,make sure they are protected from voltage spikes (use a TVS for example) if they share a circuit with other type accessories that can generate them. Most anything PW with a solenoid for example can generate large spikes.
Dale H
Access to this requires an OGR Forum Supporting Membership
