I posted before to another topic in the forum but didn't get a solution to work it out. So again, I am working on connecting my atlas switches which I have 8 as of now. The wiring is connected to the AIU and I also have the switch control button on a control board. My problem is that 6 work fine when button is pushed but other two will not throw back they seem to get in a "stuck position" going only one way and I have to manually reset the throw bar. I don't why they are doing this. When I first hooked up the switches they all were working so I know the wiring was hooked up right, since 6 are working, other 2 started sticking after a while and now they don't switch unless i move the control arm to one side. I have to say these switches are a real pain to work with I know, I know some like the Ross switches best, but some in the forum like the Atlas. Could the controller button on the switch control be bad ?. Is there better control buttons to use as replacements ? Thanks all.
Original Post
