My MTH Sharknose A/B does not operate in DCS (no engine found) It operates fine in conventional mode. It is a 8.4 volt system. Is there anything I can try to get it to work in DCS? (reset maybe?) If I get a 3V upgrade kit, how does this effect the B units smoke and proto-coupler?
Replies sorted oldest to newest
Is it proto 1 or proto 2? If proto 1 it will not run under DCS. What are the product numbers?
Dave
Thanks Bary,
I tried it this morning and it worked!!!
Never though of using this feature. If I could not enter the engine on my isolated program track, I assume the board was bad.
Have your book, albeit 1st ed.
Paul
Access to this requires an OGR Forum Supporting Membership
