I have a Z-DC1 Transformer that operated a turntable and lights. It was replaced by a Z-1000.
My question, with it small size and a short test track it could fit on my computer desk and be used to download files and updates? I then would not have to disconnect the Z-1000 from my layout?
I haven't checked, are there any concerns with DC power to TIU, AIU or Remotes
Replies sorted oldest to newest
No issue with DC. In some case it makes loading SF faster. Just make sure output Voltage is around 18-20VDC and you probably need about 1.5amps to handle the TIU and engine for SF loading.
To understand you correctly. I use max wattage 20w, will give me 1.5 amps.
That's 13 v/20w=1.5amp. Based on my Z-4000. Which can be verified by my test meter at set up time. If V-1 is not quite up to 1.5 is that going to be a problem?
It might. I load with a medium size HO transformer, but when I do the board is out of the engine. So I can control the load by not plugging in the 8 pin. My fear would be on doing this with a test track and engine, you might draw more than the power supply can handle an have it quit during a load. That would not be good.
If your PS puts out 18-20V at 20W you just at 1 amp. .3amps for TIU, .2 amps for Board, once smoke comes on and a few lights your at 1 amp and you have not tested the motor.
I just think your safer with something over 1.5 Amps. G
Access to this requires an OGR Forum Supporting Membership
