Skip to main content

Hi folks,

 

I am wiring up DZ-1008A relays driven by DZ-2500 switch machines to supply power to dead spots on the Ross Double Crossover. So far they work fine, but I noticed they hum a bit. I tried powering them both from track voltage and lower, accessory voltage. No change; the volume and pitch of the hum are exactly the same. It's not huge deal, as the hum is not very loud and operation seems fine, but I would like to address if possible.

 

My layout is powered by a Z4000 and wired for both DCS and Legacy, though the switches are operated by 2502 remote controllers for the moment.

 

Has anyone else experienced and resolved this peculiarity? If so, what was your solution?

 

Thanks everyone.

Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×