i have 2 of these switches. The switch motors are mounted on opposite sides of 2 switches and therefore the 1002 green lights are on opposite sides of the 1002’s. Is there a way to flip the lights on one so when the routes are straight the green lights are on the same sides of the 1002’s?
Replies sorted oldest to newest
If the odd one out in your picture is supposed to be red, you can swap the bulbs. If you just want to make it look like the others (green moving to red position and remaining lit) I am not sure how to do that or if it's possible.
Lots of good docs and info on the Z-stuff website. There may be info there about swapping the lit position itself instead of just the bulbs if it's possible?
rtr12 posted:If you just want to make it look like the others (green moving to red position and remaining lit) I am not sure how to do that or if it's possible.
This is what I’m trying to do. It’s easy to do with DZ2500’s. I can’t find any documentation on how to do this with DZ1000 or if it’s possible.
I just looked too and didn't see anything about it either? Seems like I once tried swapping the wires and that did not work as I recall, but I was just wanting to swap the LEDs only. Then I read the directions about swapping the LEDs themselves. Of course, that's different than what you want to do. If no one else chimes in with a way to do this, maybe a call to Z-stuff, they may have some tricks up their sleeve?
I am curious myself. Please post your solution, if discovered, and no one else posted it here.
I called Dennis and there is no way to do what I’m trying to do. The only suggestion he had was to turn the push button upside down to get the lights oriented in the same direction.
Try switching the two outer wires as well as switching the LED’s. That should work.
Access to this requires an OGR Forum Supporting Membership
