Fixed Tracks will allow PS3 engines to load but not PS2

LAZ57,

Make sure their no other equipment on that Track.

Try That. Please let us know if that's works out.

Good luck. John

First, do a signal test, on both the fixed and variable voltage tracks, using the same engine for each test. Make the engine stationary at the spot where you usually attempt to load engines on each track.

Next, swap the wires at the output of the channels, connecting each channel's outputs to the other channel's tracks. Then, repeat the same signal test that you did above.

Now, with the channel's wires still swapped, try to add a PS2 engine on the variable track.

Report your results.

Maybe check your wiring from the output of the tiu. Red to center rail.

Hi GUYZ,

  I did a signal check on the variable output and it came up a 3 out of 10.  I then switched the leads and put them on the fixed and it came up Out of Range.  I tried to start engine and nothing.

  All the PS2 engines have a BCR in them, and I allowed to sit on tracks for over a minute. 

I will check wiring next.

Gregg posted:

Maybe check your wiring from the output of the tiu. Red to center rail.

Right you are GREGG!!!  Many Thanks!!!!

BARRY track signal now are all 10s.  Thank you too!!!!!

Thank you too JOHN!!!!  For the reply!!!