Skip to main content

Hi All,

 

I have a question, i purchased a product called Arc Welder from Scenic Express and Bershire Junction is the main company.

The instructions state how to wire the 2 sets of wire for either AC or Dc. Ok so if I am just directly wiring to an MTH control

block,do I use the DC operation which says, connect the orange wire from the circuit board to the pos side of your 6-18 volt DC power and the green wire to the ground. The AC states connect the orange wire to one terminal of your 6-18 volt power supply and the green to the other terminal.

 

Thank You

Original Post

Replies sorted oldest to newest

Problem solved, wire it to the 18V AC supply.  You can either wire it to the track or an accessory transformer.  If you're connecting it to the TIU, I'd probably prefer the input side, as some products may have capacitors that will affect the DCS signal at the output side.  If you're concerned about DCS and want to wire to the track, use a 22uh choke in series with one of the power leads.

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×