I have a Hudson Dreyfuss I had not run in a while. PS3. I had difficulty adding it. Once added, sound was not working so I did a Factory reset. All fine - good sounds, however it will not move. It initially moved forward about 6 inches then stopped. No reverse, no forward. Did another factory reset - good sound , no movement. Any suggestions? ....email in profile.
Replies sorted oldest to newest
Check the wireless tether and make sure it has a good connection. In most cases you can reseat the connection and be good to go.
Clean wheels and pickups roller too? If motion cause loss of AC and everything shuts down. If tender still making sound just engine functions stopped. Drawbar and or wiring to engine is suspect. G
Thank you. The clip coming out of the Loco to the draw bar looked like it was in contact with the draw bar but it was detached just enough to cause the problem. Pushed it back in and all is fine. As usual something simple and stupid. Thanks, Marc
Access to this requires an OGR Forum Supporting Membership
