Hello, electrical is not My strong suit.I have been using the Lionel Cab-1 remote for months, with no issues.Worked fine with both Lionel and MTH locos.I bought an Atlas MP-15 recently and put it on the layout,after a few laps around everything quit.No overload lights or anything and now nothing works!Any advice or help to as what might have happened or a resolution would be greatly appreciated.
Replies sorted oldest to newest
Subscribed.
Hello..
What is your power source? ZW? 180Watt bricks? Also are you using a TPC controlled by the CAB-1 to adjust track power?
A little more detail on your setup will give us more info on where to help you.
Sounds like you are using a TPC or PowerMaster for conventional(non-command) operation? What are you using for AC power? Transformer or PowerHouse?
Here is the set up I have.
I messed with it a bit this morning.Disconnected everything and just used the brick and powerpack and all ran fine in conventional mode.
Your picture says "Image Not Found" so we'll need a bit more info.
Image appears when I view this thread.
Mautner posted:Image appears when I view this thread.
Here is what I see:
Mautner posted:Image appears when I view this thread.
That's because the coding in your post refers to a location on your own computer:
New picture?
Hope this photo works.
you said everything works in conventional mode. Do your lights work in command or nothing at all? Reason asking if you engine will light up you may just need to replace your batteries in the cab1 controller. If they get low they won't work. sometimes they will let horn and bell work sometimes not. all depends.
Access to this requires an OGR Forum Supporting Membership
