K-line factory

FfffredddOGR Forum Member

I have a kit in the polybag. No instructions.

And web photos do not show the detail I need.
Seems to be missing one part. I think it goes over the side doors. Hinged on elevated loading dock. Has a gap about 1/2" high by width of double doors.
Anyone have one and can provide photo.
Not a bad little factory. Similar to Plasticville but a little better detail.
A bit of weathering and it will find a spot in my industrial area.

Thanks.
FMH

2/18/137:58 PM

❤️ 0

Original Post

Replies sorted oldest to newest

Putnam DivisionOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

I believe the kit you are talking about started life as a Marx kit.......maybe that can help with your search for instructions.

Peter

2/18/138:13 PM

❤️ 0

baltimoretrainworksOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

Hope these help.

Jerry

2/18/138:26 PM

❤️ 0

FfffredddOGR Forum Member

Hi Jerry. The red one is the one I have. Need the detail abovef the doors on elevated loading dock. Have never seen a picture of them yet. Always obscured by canopy roof. There is a notch. Not sure what for. Can you post an image of that. Greatly appreciated. Thanks FMH

2/18/138:34 PM

❤️ 0

FfffredddOGR Forum Member

So what is it supposed to look like? I have a gap of approx 1/2" by the door width. And can not tell what is the top or bottom of the door. Anyone have any more to add? How about a picture if you have the non operating version. Just the door opening. Thanks FMH

2/18/139:25 PM

❤️ 0

FfffredddOGR Forum Member

I actually have the Marx kit. With the water tower. And I know how to put it together. Just trying to figure out what my missing piece should look like. If in fact I am missing one. Thanks FMH

2/18/139:30 PM

❤️ 0

FfffredddOGR Forum Member

I actually have the Marx kit. With the water tower. And I know how to put it together. Just trying to figure out what my missing piece should look like. If in fact I am missing one. Thanks FMH

2/18/139:30 PM

❤️ 0

FfffredddOGR Forum Member

I actually have the Marx kit. With the water tower. And I know how to put it together. Just trying to figure out what my missing piece should look like. If in fact I am missing one. Thanks FMH

2/18/139:30 PM

❤️ 0

John OchabOGR Forum Member SUPPORTING MEMBER

FMH,

I have the instructions for the K-Line Factory. One page, no picture illustrations, 11 Assembly Instructions. Send me your e-mail address, I will scan the instructions as a PDF file and e-mail you. My e-mail address should be on my personal profile.

John

2/18/139:42 PM

❤️ 0

FfffredddOGR Forum Member

Frederick_m_holland@yahoo.com

2/18/139:51 PM

❤️ 0