Hello Everyone,
I am building a control panel for power blocks and switch control. I am using Atlas 6924 non-derail boards to operate the switch machines and power routing. I also want to provide route indication on my control panel. I plan to use the J3 connector on the 6924 board to activate red and green LEDs on the panel. My question is, what kind of plug/socket should I order to connect wires to the J3 posts?
Thanks for your help
Replies sorted oldest to newest
I believe the 3 pin connectors from a computer case cooling fan will fit the 6924 pins. You can get them with wires attached on ebay or probably Amazon.
They are 0.1" spacing or 2.54mm and have the number 2510 on them.
Thanks RTR12,
I will take a look on EBAY and Amazon
I was just looking myself, all I found was lots of 300 to 1,000, way too many. I did find these 3 Pin Connector with Sockets if you don't mind waiting a few weeks for delivery. I haven't checked Amazon.
That's it! I can wait. I have to build the panel first anyway, I am sure it is going to take me a couple of weeks (at least).
Thanks for the finding them as I was not successful when I tried earlier.
The "K" series Molex are what I use. They come in 2.3.4 pin
Thanks Steve,
I just ordered them.
If you need more check these out, should the job.
Looks like this.
Use caution with these terminals. They are powered from the board and are designed for the Atlas 6931 dwarf lights. You may have to reverse the red and green wires pictured above, from the 6931 dwarf lights. There are two sets of NC/C/NO contacts available on the board.
The 6931 dwarf lights are also designed to hook directly to the Atlas switch motors, there is a small PC Board included with the lights. It was more convenient for me to wire the boards to the switch motors, since the 6924 boards are in one location.
Access to this requires an OGR Forum Supporting Membership
