Anyone experienced problems with the bridge just lifting on one side ? When raising or lowering, the pullies at the top of bridge on one side are turning but the other side is not. Solution ? I have checked the wiring and everything seems ok.
Replies sorted oldest to newest
Sounds like one of the angled gears on the side that is not lifting is loose from the drive shaft. Use an allen head wrench to tighten the set screw on the drive shaft (that extends across the span) and it should resolve your issue.
Mike
Thanks for the tip. That's exactly what I figured out a few days ago via trial and error. Tiny hole in the gear in which the adjustment screw in down in. I used a very small phillips head screw driver to tighten. Didn't realize it needs an allen wrench to tighten. Will reinvestigate this if it stops working again, for now, seems to be lifting fine.
Access to this requires an OGR Forum Supporting Membership
