Would anyone happen to know the proper positioning of the centering spring, I know it goes under the plate with the retaining sleeve, not to sure of the slots it will set in, this is for the whistle/direction switch shift assembly.
Original Post
Replies sorted oldest to newest
Sorry, I meant shaft assembly. Thank You, Frank
The tang in the shaft straddles the two cutouts and the spring protrudes through the slots and captures the tang so that it returns to center when the handle is released. Same as a 1033, just offset a little.
@Jon G posted:The tang in the shaft straddles the two cutouts and the spring protrudes through the slots and captures the tang so that it returns to center when the handle is released. Same as a 1033, just offset a little.
Jon, Thanks for your help, i'm not sure which slot or slots should the spring protrude from once in place from the underside of the plate, the plate has two oval slots and one round as shown in my pictures.
